reset att uverse cisco receiver to factory defaults

If the Ethernet light is off, check if both ends of the Ethernet cable is properly secured on the Ethernet port of the computer and on the WAP. Blinking (Green) - Transmitting or receiving data.Step 4Ĭheck the Ethernet light on your WAP and observe its normal state as follows: This would help identify if the problem is on the power adapter, the power outlet, or the device itself. If the Power light is off, plug it to another power outlet or try using another power adapter of the same specification then check the Power light again. Blinking (Amber) - Detecting hardware failure.Blinking (Green) - Booting or System Self-Test or acquiring IP address.Step 2Ĭheck the Power light on your WAP and observe its normal state as follows: To verify PoE power source on your access point, click here. Check your devices documentation whether it is capable of 802.3af or the High Power 802.3at PoE standard and verify if your switch or router can provide it to the WAP. Note: Take note of the PoE type that your WAP requires to make sure it is receiving full power supply from your router or switch. If it uses AC power adapter, make sure the power adapter is connected properly to the power port and is plugged in to the power outlet. If your WAP uses power through Power over Ethernet (PoE), make sure that the Ethernet cable that connects it from the Ethernet port to the PoE source is properly connected. The images used in this article are taken from the WAP321. Note: Images may vary depending on the exact model of your WAP. Identify Hardware Failure Check the Physical Connection and Lights

Reset att uverse cisco receiver to factory defaults